2-layer system in 1 day
Farmcoat is not only suitable for the agricultural sector. An increasing number of dog kennel or dog boarding owners make inquiries to Farmcoat.
For dog kennels or dog boarding facilities, it is naturally important to have an easy-to-clean floor. Applying Farmcoat Floor Coating creates a seamless surface where dirt cannot get trapped. The surface is easy to clean with a hose or even a pressure washer.
In addition, the surface is rough enough to prevent dogs from slipping with their paws. Depending on your requirements, an anti-slip additive can be added. The anti-slip is rough, but the surface can still be thoroughly cleaned with a floor squeegee.
Curious about the possibilities for your dog kennel or dog boarding facility? Contact us without obligation!
How long does it take to apply a coating in a dog kennel/dog boarding facility?
Farmcoat is a two-layer floor coating consisting of a primer and a coating. The coating can be applied 4 hours after applying the primer. You will therefore be finished coating within 1 day. However, please bear in mind that you must thoroughly clean the substrate the day before so that it can dry properly before you start coating. After applying the coating, it must dry/cure for 12 hours. Therefore, please bear in mind that you cannot use the substrate for at least a day and a half.
In which colors is the coating available?
Our coatings are available as standard in transparent or RAL 7001 (grey). Upon request and with a minimum total order of 50 kilos, you can choose from any RAL or NCS color.
Does the coating contain anti-slip?
The coating provides a rough yet smooth finish. If you need additional anti-slip, or even a very coarse anti-slip (walking surface for livestock), we can offer this as a custom solution.
How thick should the coating be applied?
You can apply the coating in very thick layers. Allow up to 2 kilos per square meter. For very worn substrates, it has a leveling effect.
Is it easy to apply yourself?
Farmcoat has been developed so that it is still easy for laypeople/inexperienced people to apply. With every order, we standardly supply a detailed manual in which clearly describes the steps of how the coating is applied.
What accessories do I need?
For anyone planning to coat, we recommend the following accessories:
- 1x large bracket (25 cm)
- 2x large rollers (25 cm)
- 1x small bracket (10 cm)
- 2x small roller (10 cm)
- 2x brush
- 1x mixing stick
- 1x mixing rod
