Farmcoat Epoxy Mortar

Do you have small or large holes in your floor or wall? Does your concrete need to be repaired, filled or raised? Then use Farmcoat Epoxy Mortar. This mortar is waterproof, highly abrasion-resistant and can be applied in very thick layers (up to about 10 cm).

Farmcoat Epoxy Mortar is available as a 2.5 kg set or a 20 kg set.

• Very hard and wear-resistant
• Watertightness
• Fills holes well and can be sanded
• Paintable
• For use on wood, steel, concrete and other mineral substrates.

The mortar consists of:

• Farmcoat Epoxy Resin (resin+hardener)
• Farmcoat mortar filler sand

Mixing ratio and consumption: The amount of sand to be added can be adjusted as required.

Recommendation when used as a raising casting compound: 20 kg set – Combine the 5.15 kg resin with 10-12 kg of Farmcoat Mortar sand (approx. 3/4 of the total quantity of sand). You will then have a total of 15-17 kg ready-to-use mortar (approx. 8 litres).

Recommended as a filling repair mortar: 20 kg set – Combine the 5.15 kg of resin with the entire 14.85 kg of Farmcoat Mortar sand. You will then have a total of 20 kg of ready-to-use mortar (approx. 10 litres).

Procedure: First mix the resin components. Then gradually add the sand mix using a mixer attached to a drill. For large quantities, do this in a mortar tub or sturdy large bucket. Mix it until you have an even mass. Apply the mortar mix with a putty knife, hand trowel or flat trowel. We recommend using a mixer with a larger head for large quantities.

Processing time for the mortar mix: approx. 60 minutes (after 60 minutes it slowly thickens)

Cured/loadable after approx. 12 hours at 20 degrees Celsius.

The substrate must be clean, dry and stable. Loose and brittle pieces of concrete and/or flaky pieces of old coating should be removed.